Industrial waste gas purification and treatment equipment
Working principle of exhaust gas purification tower
The purification type depends on the waste gas type , processing volume and requirements . The ultimate goal is non-pollution discharge by an optimized combination of high efficiency and low cost.
The waste gas equipment separates polluted substances from the gas and change them into non-polluted the wastegas equipment separates polluted substances from the gas and change them into non-polluted substances . lt is a reversemicro-contact type with a tower filer that provides big enough area allows air and liquid contact while cause not too bigresistance . Absorbent is the major media that recovers wastes , which is mole-proportional as the volume of absorbent toinert gas .
Waste gas exhaust from pipe and going up , passing through the filler layer cycled absorbent is sprayed evenly fromtower top through a liquid distributor , and flows down through the filler layer and enters recycling water tank eventually .The rising air keeps good contact with dripping absorbent in the filler layer, so that the density of the poisonous substancesin the gas gets lower and lower , until meeting the discharge requirements when it reaches the top of the tower.
Performance parameters
Online Inquiry
Contact information
Recommended Products
s
e
r
v
i
c
e
Guangdong Chuangtianlong Environmental Protection Equipment Technology Co., Ltd.
Address: No. B03-05, Zhongshan Torch (Yangxi) Industrial Transfer Industrial Park, Yangxi County
Phone: +86-755-28070186 +86-755-29538772
Mobile: +86-13751027007
Fax: +86-755-28179500
Email: szctl@sz-cl.com
Copyright © 2021 Guangdong Chuangtianlong Environmental Protection Equipment Technology Co., Ltd. 粤ICP备11023282号 Powered by 300.cn Jiangmen